Scytek-electronics 100RS Instrukcja Użytkownika Pobierz pdf (Strona 13)

Astra 100RS - Page 9

+12V or ground only when the parking lights are on and set the internal parking light relay

jumper to the proper polarity. For parking light circuits exceeding 10 amps, a relay is required.

For vehicle’s with independent left and right parking light circuits, diodes must be installed to

keep the circuits separate. NOTE: Do not connect the WHITE wire to the vehicle’s headlight

circuit.

Pin 16 RED WIRE: Module Power Input (+). Connect to a constant source of +12V.

2-Pin Blue Connector: Valet switch port. Mount switch where it is accessible from the driver’s

position.

2-Pin Red Connector: LED port. Mount LED where it may be easily seen from either side of the

vehicle.

3-Pin White Connector: Not used.

5-Pin White Flat Connector: Antenna connector port.

Starter doesn’t start and Parking Lights flash:

3 Times - Hood Trigger is active

4 Times - Brake Lights stay On

5 Times - Unit is in Valet (service) mode, and start is disabled.

6 Times - Handbrake Off (Manual Transmission Mode Only).

7 Times - Start sequence not initiated (Manual Transmission Mode Only).

Starter

Diagnostics

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Brak uwag

Scytek-electronics 100RS Instrukcja Użytkownika Strona 13