Scytek-electronics ASTRA 70000000 Instrukcja Użytkownika Pobierz pdf (Strona 19)

Astra 7E7 - Page 15

System

Wiring

14-Pin Main Harness

Pin 1 RED WIRE: +12V Battery Input (15A Fuse). The RED wire must be connected to a clean source of

continuous +12V power.

Pin 2 WHITE WIRE: Parking Light Output (+/-) relay. Connect the White wire to the circuit that shows

+12V or ground only when the parking lights are on and set the internal parking light relay jumper to

the proper polarity. For parking light circuits exceeding 10 amps, a relay is required. For vehicle’s with

independent left and right parking light circuits, diodes must be installed to keep the circuits separate.

NOTE: Do not connect the WHITE wire to the vehicle’s headlight circuit.

Pin 3 BROWN WIRE: Siren Output (+) 3A. The BROWN wire must connect to the siren’s red wire. The

BLACK siren wire must be grounded.

Pin 4 BLUE/WHITE: Passenger Unlock output (-) 500mA. Connect to an optional relay to unlock the

passenger doors for two-stage unlock (see Two Stage Door Lock Diagrams).

Pin 5 WHITE/RED WIRE: Auxiliary 2 Output (-) 500mA. Connect to a relay or module for an optional

feature such as power window activation or remote start, etc.

Pin 6 ORANGE WIRE: Armed Output (-) 500mA. The ORANGE wire provides a ground output while armed

to activate an optional starter defeat relay or other device such as a power window control module.

Pin 7 BROWN/WHITE WIRE: Horn Output (-) 500mA. Connect to an optional relay to activate the

vehicle’s horn when the alarm is triggered.

Pin 8 BLACK/WHITE WIRE: Dome Light Relay Output (+/–) 7A. Connect to the wire that activates the

vehicle’s dome light, usually the door pin switch wire. NOTE: The dome light output may usually connect

to the same wire used for the door trigger input (See GREEN or VIOLET door trigger wires).

Pin 9 BLUE WIRE: Trunk/Hood trigger Input (-). Connect the BLUE wire to the trunk and/or optional hood

pin switches. The switch must provide a ground output when opened.

Pin 10 GRAY WIRE: Auxiliary 1 Output (-) 500mA. Connect to a relay or module for an optional feature

such as trunk release, etc.

Pin 11 YELLOW WIRE: +12V Ignition Input. The YELLOW wire must connect to a main ignition wire at the

ignition harness. This wire must show +12V when the ignition is on.

Pin 12 BLACK WIRE: Ground Input (-). The BLACK wire must connect to a solid chassis ground. Clean away

any paint or dirt to insure the best possible ground.

Pin 13 VIOLET WIRE: Positive door trigger Input (+). Connect to the door switch circuit wire that shows

+12V when the door is open. This type of door circuit is usually found on Ford

vehicles.

Pin 14 GREEN WIRE: Negative door trigger Input (-). Connect to the door switch circuit wire that shows

ground when the door is open.

5-Pin Door Lock Harness

Pin 1 WHITE WIRE: Lock Relay Pin 87a (Normally Closed).

Pin 2 GREEN WIRE: Lock Relay Pin 30 (Common).

Pin 3 BLUE WIRE: Unlock Relay Pin 30 (Common).

Pin 4 BROWN WIRE: Unlock Relay Pin 87a (Normally Closed).

Pin 5 VIOLET WIRE: Lock/Unlock Relays Pin 87 (Normally Open) [10A Fuse].

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

Komentarze do niniejszej Instrukcji

Brak uwag

Scytek-electronics ASTRA 70000000 Instrukcja Użytkownika Strona 19

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Alarm samochodowy Scytek-electronics ASTRA 70000000